3 results
Search Results
Now showing 1 - 3 of 3
Article Citation - WoS: 31Citation - Scopus: 37Behavior of Steel-Concrete Partially Composite Beams With Channel Type Shear Connectors(Elsevier Sci Ltd, 2014) Baran, Eray; Topkaya, CemThis paper summarizes the findings of an experimental study investigating the flexural behavior of partially composite beams incorporating channel type shear connectors. Results from monotonic load testing of four full-scale steel-concrete composite beams and a steel beam are presented. The main effort focused on identifying the variation of strength and stiffness properties of beams with various degrees of partial composite action. Behavior of channel shear connectors in the composite beam specimens is related to those previously obtained from push-out tests of similar connectors. Finally, recommendations of the related AISC Specification on the strength and stiffness of composite beams are used for the assessment of the influence of the degree of partial composite action on flexural behavior. The experimental results revealed that even for beams with relatively low degree of partial composite action, major improvement on moment capacity and stiffness was obtained as compared to the steel specimen. The measured moment capacity of both the partially composite and fully composite beams agreed acceptably with the calculated capacities. The effective moment of inertia and the lower bound moment of inertia as specified by the AISC Specification were observed to overestimate the measured flexural stiffness of beams for all degrees of partial composite action investigated. (C) 2014 Elsevier Ltd. All rights reserved.Article Citation - WoS: 69Citation - Scopus: 78An Experimental Study on Channel Type Shear Connectors(Elsevier Sci Ltd, 2012) Baran, Eray; Topkaya, CemThis paper describes an experimental study on European channel shear connectors. While shear studs are widely used in steel-concrete composite elements, the channel connectors are also gaining popularity due to their certain advantages. The channel connectors do not require special equipment and standard welding procedures are adequate for attachment purposes. In addition, this type of connector offers higher amounts of shear resistance due to its high contact area with surrounding concrete. Although first studies date back to 1950s. little work has been done in the past to investigate their behavior. Majority of the work done to date was on channel connectors used in North America with a very limited parameter range. An experimental study consisting of 15 push-out tests was carried out to investigate the behavior of European type channel connectors with various heights and lengths. The ultimate resistance of the connectors obtained from experiments was compared against those predicted by North American steel design specifications. It was observed that the equations presented in American and Canadian specifications are too conservative. Based on a model that represents the typical failure mechanism in push-out tests, a new equation was developed for the ultimate resistance of channel shear connectors. It is shown that the developed equation is capable of predicting the ultimate resistance of channel connectors with reasonable accuracy. (C) 2012 Elsevier Ltd. All rights reserved.Article Citation - WoS: 4Evaluation of Boron Ore in Cement Production(Taylor & Francis inc, 2012) Yesilmen, Seda; Gurbuz, AyhanA new genre of high belite cement named boron-modified active belite (BAB) cement that was developed using byproduct of boric acid production was investigated. The cement proved superior in compressive strength and permeability characteristics in the previous studies. Long term storage of cement is known to alter the mechanical properties of concrete made with the aged cement. The article investigated the BAB cement in aged condition-stored in silos for about three years-variations of mechanical and physical properties of specimens during a one-year period. An additional comparison is also performed with specimens cast using fresh Ordinary Portland Cement (OPC) of the same grade in order to present the development of mechanical and physical properties in a qualitative manner. Lower 28 day compressive strength values are observed for BAB cement compared to OPC specimens; however, higher rate of strength development of BAB cement resulting from high belite content led to comparable long term strength values with OPC specimens.
