3 results
Search Results
Now showing 1 - 3 of 3
Article Citation - WoS: 8Effect of H2o Ratio on Photocatalytic Activity of Sol-Gel Tio2 Powder(Ice Publishing, 2013) Agartan, Lutfi; Kapusuz, Derya; Park, Jongee; Ozturk, AbdullahEffect of water/tetraethyl orthotitanate molar ratio (R) on the formation and morphology of sol-gel-derived titania powder has been studied. Solutions for R of 3 and 5 have been prepared. Initial viscosity of the solutions and viscosity of the gels prepared by aging the solutions for some time were measured. Results revealed that lower gel viscosities lead to better crystallization of the aerogel. Aerogels were dried at 80 degrees C for 24 h and then calcined at 300 degrees C for 1 h to obtain titania powders. The structural and morphological analyses of the powders were performed using X-ray diffraction and scanning electron microscopic characterization techniques. Titania particles obtained after calcination composed of only anatase phase and were in the size range of 9-50 nm. The photocatalytic activity of the powders was evaluated in terms of the degradation of methylene blue (MB) solution under UV (ultraviolet) illumination. A diffuse reflectance spectroscopy was used for the band gap energy measurements. Results revealed that R had a profound effect on the particle morphology and photocatalytic activity of sol-gel-derived titania powders. The titania powders prepared from the solution for R of 5 degraded 99.47% of MB solution under UV illumination in 90 min.Article Citation - WoS: 3Citation - Scopus: 4Friction and Wear Behavior of Selected Dental Ceramics(World Scientific Publ Co Pte Ltd, 2009) Park, Jongee; Pekkan, Gurel; Ozturk, AbdullahThe purpose of this study was to determine the friction coefficients and wear rates of six commercially available dental ceramics including IPS Empress 2 (E2), Cergo Pressable Ceramic (CPC), Cercon Ceram (CCS) and Super porcelain EX-3 (SPE). Bovine enamel (BE) was also tested as a reference material for comparison purposes. Samples of the dental ceramics were prepared according to the instructions described by the manufacturers in disk-shape with nominal dimensions of 12 mm x 2 mm. The wear tests were performed by means of a pin-on-disk type tribometer. The friction coefficients and specific wear rates of the materials were determined at a load of 10 N and rotating speed of 0.25 cm/s without lubrication. Surface morphology of the wear tracks was examined using a scanning electron microscope. Statistical analyses were made using one-way ANOVA and Turkey's HSD (P < 0.05).Article Citation - WoS: 4Citation - Scopus: 4Bioactivity of Apatite-Wollastonite Glass-Ceramics Produced by Melting Casting(World Scientific Publ Co Pte Ltd, 2013) Park, Jongee; Ozturk, AbdullahGlass-ceramics containing only apatite and wollastonite crystals were produced in the system MgO-CaO-SiO2-P2O5-F by the melt casting process. The bioactivity of the glass-ceramics was determined by immersing the glass-ceramics in a simulated body fluid (SBF) and by assessing the resulting apatite formation on the free surface after various immersion durations. A 12-mu m-thick apatite layer formed on the surface of the glass-ceramic containing only apatite crystals after 20 days immersion in SBF. However, the thickness of the apatite layer formed on the surface of the glass-ceramic containing apatite and wollastonite crystals was 1 mu m. Results have shown that the bioactivity of glass-ceramic depends strongly on the type of crystal(s) developed during the glass-ceramic process and their proportion in the glassy matrix.
