5 results
Search Results
Now showing 1 - 5 of 5
Article Citation - WoS: 8Citation - Scopus: 10Temperature Effects on Optical Characteristics of Cdse Thin Films(Elsevier Sci Ltd, 2021) Gullu, H. H.; Isik, M.; Surucu, O.; Gasanly, N. M.; Parlak, M.CdSe is one of the significant members of II-VI type semiconducting family and it has a wide range of technological applications in which optoelectronic devices take a special position. The present paper reports the structural and optical characteristics of thermally evaporated CdSe thin films. XRD pattern exhibited preferential orientation along (111) plane while atomic composition analyses resulted in the ratio of Cd/Se as closer to 1.0. Temperature-dependent band gap characteristics of CdSe thin films were investigated for the first time by carrying out transmission experiments in the 10-300 K range. The analyses showed that direct band gap energy of the compound decreases from 1.750 (at 10 K) to 1.705 eV (at 300 K). Varshni model was successfully applied to the temperature-band gap energy dependency and various optical constants were determined. Raman spectrum of CdSe thin films was also presented to understand the vibrational characteristics of the compound. The present paper would provide worthwhile data to researchers especially studying on optoelectronic device applications of CdSe thin films.Article Citation - WoS: 18Citation - Scopus: 18Fabrication of Al/Mgo and C/Mgo Tunneling Barriers for Tunable Negative Resistance and Negative Capacitance Applications(Elsevier Science Bv, 2013) Qasrawi, A. F.In this work, the design and characterization of magnesium oxide based tunneling diodes which are produced on Al and InSe films as rectifying substrates are investigated. It was found that when Al thin films are used, the device exhibit tunneling diode behavior of sharp valley at 0.15 V and peak to valley current ratio (PVCR) of 11.4. In addition, the capacitance spectra of the Al/MgO/C device show a resonance peak of negative capacitance (NC) values at 44.7 MHz. The capacitance and resistance-voltage characteristics handled at an ac signal frequency of 100 MHz reflected a build in voltage (V-bi) of 1.29 V and a negative resistance (NR) effect above 2.05 V. This device quality factor (Q)-voltage response is similar to 10(4). When the Al substrate is replaced by InSe thin film, the tunneling diode valley appeared at 1.1 V. In addition, the PVCR, NR range, NC resonance peak, Q and lib; are found to be 135, 0.94-2.24 and 39.0 MHz, similar to 10(5) and 1.34 V, respectively. Due to the wide differential negative resistance and capacitance voltage ranges and due to the response of the C/MgO/InSe/C device at 1.0 GHz, these devices appear to be suitable for applications as frequency mixers, amplifiers, and monostable-bistable circuit elements (MOBILE). (c) 2013 Elsevier B.V. All rights reserved.Article Citation - WoS: 3Citation - Scopus: 6Structural and Optical Properties of Thermally Evaporated Cu-Ga (cgs) Thin Films(Elsevier, 2018) Gullu, H. H.; Isik, M.; Gasanly, N. M.The structural and optical properties of thermally evaporated Cu-Ga-S (CGS) thin films were investigated by Xray diffraction (XRD), energy dispersive X-ray spectroscopy (EDS), atomic force microscopy (AFM) and optical transmittance measurements. The effect of annealing temperature on the results of applied techniques was also studied in the present paper. EDS results revealed that each of the elements, Cu, Ga and S are presented in the films and Cu and Ga concentration increases whereas S concentration decreases within the films as annealing temperature is increased. XRD pattern exhibited four diffraction peaks which are well-matched with those of tetragonal CuGaS2 compound. AFM images were recorded to get knowledge about the surface morphology and roughness of deposited thin films. Transmittance measurements were applied in the wavelength region of 300-1000 nm. Analyses of the absorption coefficient derived from transmittance data resulted in presence of three distinct transition regions in each thin films with direct transition type. Crystal-field and spin-orbit splitting energies existing due to valence band splitting were also calculated using quasicubic model.Article Citation - WoS: 10Citation - Scopus: 10Temperature Dependent Band Gap in Sns2x< (x=0.5) Thin Films(Elsevier Sci Ltd, 2020) Delice, S.; Isik, M.; Gullu, H. H.; Terlemezoglu, M.; Surucu, O. Bayrakli; Gasanly, N. M.; Parlak, M.Structural and optical properties of SnS2xSe(2-2x) thin films grown by magnetron sputtering method were investigated for composition of x = 0.5 (SnSSe) in the present study. X-ray diffraction, energy dispersive X-ray spectroscopy, atomic force microscopy and scanning electron microscopy methods were used for structural characterization while temperature-dependent transmission measurements carried out at various temperatures in between 10 and 300 K were accomplished for optical investigations. X-ray diffraction pattern of studied composition presented peaks at positions which are between those of SnSe2 and SnS2. Transmittance spectra recorded at all applied temperatures were analyzed using well-known Tauc relation. Analyses revealed the direct band gap energy value of SnSSe thin films as 1.75 eV at room temperature. Change of band gap energy as a response to varying temperature were discussed in the study by utilizing Varshni relation. It was shown that variation of gap energy values was well-matched with the Varshni's empirical formula. Energy band gap at absolute zero and rate of change of band gap with temperature were found to be 1.783 eV and -2.1 x 10(-4) eV K-1, respectively.Article Citation - WoS: 13Citation - Scopus: 12Electro-Optical Properties of Poly[di(2-Thiophenyl)carborane] and Its Opto-Electronic Application(Elsevier Science Sa, 2013) Cansu-Ergun, Emine Gul; Cihaner, AtillaElectrochemical and optical properties of a hybrid carborane based polymer called poly(di(2-thiophenyl)carborane) (P1) obtained electrochemically were reported as well as its electrochromic device application. Thiophene donor units and m-carborane acceptor unit were combined under the same umbrella via donor-acceptor-donor approach to obtain di(2-thiophenyl)carborane (1). Contrary to the literature, extreme conditions like highly dried solvent or inert atmosphere were not used for polymerization and characterization. Polymer P1 has an ambipolar character since it exhibited a reversible oxidation peak at a half wave potential (E-1/2) of 1.08 V and a quasi reversible reduction peak at E-1/2 = -1.82 V vs. Ag/AgCl. The polymer film has an optical band gap of 1.95 eV with a maximum absorption band centered at 488 nm. Also, it exhibited multicolor electrochromic behavior between its reduced and oxidized states changing from dark orange to light blue. Furthermore, the electrochromic device prepared based on P1 film was stable and robust. (C) 2013 Elsevier B.V. All rights reserved.
