2 results
Search Results
Now showing 1 - 2 of 2
Article Citation - WoS: 1Citation - Scopus: 1Normalized Thermodynamic Model for Intermittent Energy Systems and Application To Solar-Powered Adsorption Cooling Systems(int Center Applied thermodynamics, 2011) Taylan, Onur; Baker, Derek K.; Kaftanoglu, BilginA new normalized model is developed to quantify and explore trends in coincidence of supply and demand in generic intermittent energy systems as key design and operating parameters are varied. This novel model is applied to seasonal-transient simulations for a solar-thermal powered adsorption system with and without heat recovery to investigate the coincidence between the solar-supplied cooling power and cooling load in terms of seasonal solar and loss fractions. Additionally, the system's basic performance trends are investigated as a number of parameters are varied. Results for the conditions explored include the following. The solar fraction increases and the loss fraction decreases with increases in storage capacity, and both fractions decrease with increases in maximum bed temperature. The required evacuated tube collector area is smaller than the flat plate collector area while the required mass of adsorbent is independent of collector and adsorption cycle types. Simulation results also show the effects of operating conditions and several design parameters on the system's COP.Article Citation - WoS: 16Citation - Scopus: 19Cop Trends for Ideal Thermal Wave Adsorption Cooling Cycles With Enhancements(Elsevier Sci Ltd, 2012) Taylan, Onur; Baker, Derek K.; Kaftanoglu, BilginModels are presented for ideal thermal wave adsorption cooling cycles without mass recovery, with adiabatic mass recovery and with isothermal mass recovery. Coefficient of performance (COP) values obtained from simulations are compared with the results of a reversible cycle and previously developed models for a simple cycle and heat recovery cycle with two spatially isothermal beds (2SIB). The effects of maximum and minimum bed temperatures, bed's dead mass, and condensation and evaporation temperatures on COP were investigated. The thermal wave cycle has significantly higher COP's than the simple and 2SIB cycles. For the conditions investigated, adding mass recovery to the thermal wave cycle does not affect its COP significantly. The COP of the thermal wave cycle increases with increasing maximum bed and evaporation temperatures and decreasing minimum bed and condensation temperatures. Unlike for the simple and 2SIB cycles, variations in the bed's dead mass have minimal impact on COP. (C) 2010 Elsevier Ltd and IIR. All rights reserved.
