4 results
Search Results
Now showing 1 - 4 of 4
Article Citation - WoS: 5Citation - Scopus: 5Structural and Electrical Characterizations of the as Grown and Annealed Au/Mοo3< Bandpass Filters(Wiley, 2019) Khanfar, Hazem K.; Qasrawi, Atef; Daraghmeh, Masa; Abusaa, MuayadIn this work, the structural, morphology, and electrical properties of two 500 nm thick molybdenum trioxide layers that are sandwiched with indium slab of thickness of 200 nm (MoO3/In/MoO3 [MIM]) to form a bandpass filter are investigated by X-ray diffraction (XRD), scanning electron microscopy (SEM), energy dispersive X-ray spectroscopy (EDX), and impedance spectroscopy techniques, respectively. The MIM films which coated onto Au thin film substrates by the thermal evaporation technique under vacuum pressure of 10(-5) mbar was post annealed at 250 degrees C in air atmosphere. While the XRD analysis revealed polycrystalline hexagonal lattice structure of the Au/MLM samples, the SEM and EDS analysis displayed grains of sizes of 350 nm and stoichiometric structure of MoO3. Electrically, indium layer which caused n-type conduction with donor level of 299 meV, forced the material to exhibit negative capacitance (NC) effect at high frequencies (above 1.1 GHz). The impedance spectroscopy which was recorded in the frequency domain of 0.01 to 1.80 GHz, also revealed low pass and high pass filters characteristics in the low and high frequency domains, respectively. The annealing of the Au/MIM samples, decreased the crystallite and grain sizes and increased the microstrain, the defect density and the stacking faults. Small amount of excess oxygen and some indium deficiency are observed upon annealing. In addition, the annealing shifted the donor level closer to the bottom of the conduction band and inverted the NC effect from high to low frequency regions. The study indicates the applicability of the Au/MIM/C structures as microwave cavities and parasitic capacitance cancellers in electronic circuits.Article Citation - WoS: 3Citation - Scopus: 3Enhancement of the Performance of the Cu2se Band Filters Via Yb Nanosandwiching(Wiley, 2019) Khusayfan, Najla M.; Qasrawı, Atef Fayez Hasan; Qasrawi, A. F.; Khanfar, Hazem K.; Qasrawı, Atef Fayez Hasan; Department of Electrical & Electronics Engineering; Department of Electrical & Electronics EngineeringIn this article, we report the experimental and theoretical modeling on the band pass filters that are made of two thin film layers of Cu2Se coated onto aluminum substrates and nanosandwiched with 50 nm ytterbium layers. The nanosandwiching of Yb between two layers of Cu2Se is found to decrease the lattice constant, the defect density, and the strain and increase the grain size in the Cu2Se. Electrically, it is observed that, Al/Cu2Se/Al structure exhibits wave trap characteristics with notch frequency of 1.31 GHz. The Yb-layers improved the performance of the band pass filters by increasing the amplitude of the reflection coefficients, increasing the return loss values and decreasing the voltage standing wave ratios. The calculated conduction and wave trapping parameters nominate the Yb-nanosandwiched Cu2Se films for use in communication technology as they exhibit negative capacitance effect and narrow band pass range.Article Citation - WoS: 16Al/Moo3< Broken Gap Tunneling Hybrid Devices Design for Ir Laser Sensing and Microwave Filtering(Ieee-inst Electrical Electronics Engineers inc, 2020) Qasrawi, Atef F.; Khanfar, Hazem K.Herein the design of broken gap heterojunction devices made of molybdenum trioxide and zinc phthalocyanine coated onto Al substrates are reported. The devices which are prepared by the thermal evaporation technique under vacuum pressure of 10(-5) mbar are observed to exhibit a conduction and valence band offsets of 3.36 and 3.56 eV, respectively. The heterojunction devices are observed to form a subband gap of 0.66 eV between the valence bands edges of p- ZnPc and conduction bands edges of p-MoO3 leading to a p(+)/n(+) heterojunction type. Analysis of the current-voltage characteristics of the devices has shown that it exhibits tunneling diode characteristics with maximum tunneling barriers of width of similar to 45 nm. The device displayed biasing dependent photosensitivity in response to 850 nm laser lights. In addition to its characteristics as MOS device, when it was imposed with ac signals in the frequency domain of 0.01-1.80 GHz, it displayed resonance-antiresonancephenomena accompanied with negative capacitance effect in the studied range of spectra. The analysis of the alternating current (ac) electrical conductivity has shown that the ac conduction is mostly governed by quantum mechanical tunneling assisted with correlated barriers hopping. The laser light photosensitivity, the negative capacitance effect, the capacitance switching within 100 ns and the bandpass characteristics with notch frequency of 1.24 GHz make the Al/MoO3/ZnPc/Al attractive for use as IR sensors, parasitic capacitance cancellers, fast capacitance switches and microwave bandpass filters.Article Citation - WoS: 8Citation - Scopus: 7Negative Capacitance Effect in Ag/-in2< Dual Band Stop Filters(Springer, 2019) Khanfar, Hazem K.; Qasrawi, A. F.; Shehada, Sufyan R.In the current study, a 1.5m thick three channel microwave band filter is designed and characterized. The thin film device which was constructed from the indium selenide, cadmium sulfide and cadmium selenide stacked dielectric materials sandwiched between silver and carbon films is studied by means of x-ray diffraction, energy dispersive x-ray analysis and impedance spectroscopy techniques. It was observed that the Ag thin film substrate induced the formation of the hexagonal -In2Se3 phase of indium selenide. The x-ray analysis has also shown that the deposition of hexagonal CdS over Ag/-In2Se3 and that of hexagonal CdSe over -In2Se3/CdS under vacuum pressure of 10(-8) bar is of a highly strained and mismatched physical nature. The impedance spectroscopy analysis in the frequency domain of 0.10-1.80GHz has shown that; while the Ag/-In2Se3/C channel exhibit negative capacitance (NC) effects in the frequency domain of 0.10-1.40GHz, the Ag/-In2Se3/CdS/C and the Ag/-In2Se3/CdS/CdSe/C channels displayed a NC feature in the domains of 1.24-1.40GHz and 1.10-1.56GHz, respectively. The fitting of the capacitance spectra in accordance with the modified Ershov model allowed determining the NC and band filtering parameters. It was also observed that, although the Ag/-In2Se3/C channel behaves as a high frequency low pass filter, the second and third channels displayed band stop filter features with notch frequencies of 1.38GHz and 1.49GHz, respectively. The features of the device nominate it for use as a parasitic capacitance canceller and as a three channels microwave filter.
