6 results
Search Results
Now showing 1 - 6 of 6
Correction Citation - WoS: 1Citation - Scopus: 2Supported Copper-Copper Oxide Nanoparticles as Active, Stable and Low-Cost Catalyst in the Methanolysis of Ammonia-Borane for Chemical Hydrogen Storage (vol 165, Pg 169, 2015)(Elsevier, 2016) Yurderi, Mehmet; Bulut, Ahmet; Ertas, Ilknur Efecan; Zahmakiran, Mehmet; Kaya, Murat[No Abstract Available]Article Citation - WoS: 141Citation - Scopus: 147Carbon Dispersed Copper-Cobalt Alloy Nanoparticles: a Cost-Effective Heterogeneous Catalyst With Exceptional Performance in the Hydrolytic Dehydrogenation of Ammonia-Borane(Elsevier, 2016) Bulut, Ahmet; Yurderi, Mehmet; Ertas, Ilknur Efecan; Celebi, Metin; Kaya, Murat; Zahmakiran, MehmetHerein, we report the development of a new and cost-effective nanocatalyst for the hydrolytic dehydrogenation of ammonia-borane (NH3BH3), which is considered to be one of the most promising solid hydrogen carriers due to its high gravimetric hydrogen storage capacity (19.6 wt%) and low molecular weight. The new catalyst system consisting of bimetallic copper-cobalt alloy nanoparticles supported on activated carbon was simply and reproducibly prepared by surfactant-free deposition-reduction technique at room temperature. The characterization of this new catalytic material was done by the combination of multi-pronged techniques including ICP-MS, XRD, XPS, BFTEM, HR-TEM, STEM and HAADF-STEM-line analysis. The sum of their results revealed that the formation of copper-cobalt alloy nanoparticles (d(mean) =1.8 nm) on the surface of activated carbon (CuCo/C). These new carbon supported copper-cobalt alloy nanoparticles act as highly active catalyst in the hydrolytic dehydrogenation of ammonia-borane, providing an initial turnover frequency of TOF = 2700 h(-1) at 298 K, which is not only higher than all the non-noble metal catalysts but also higher than the majority of the noble metal based homogeneous and heterogeneous catalysts employed in the same reaction. More importantly, easy recovery and high durability of these supported CuCo nanoparticles make CuCo/C recyclable heterogeneous catalyst for the hydrolytic dehydrogenation of ammonia-borane. They retain almost their inherent activity even at 10th catalytic reuse in the hydrolytic dehydrogenation of ammonia-borane at 298K. (C) 2015 Elsevier B.V. All rights reserved.Article Citation - WoS: 136Citation - Scopus: 148Palladium(0) Nanoparticles Supported on Silica-Coated Cobalt Ferrite: a Highly Active, Magnetically Isolable and Reusable Catalyst for Hydrolytic Dehydrogenation of Ammonia Borane(Elsevier, 2014) Akbayrak, Serdar; Kaya, Murat; Volkan, Murvet; Ozkar, SaimPalladium(0) nanoparticles supported on silica-coated cobalt ferrite (Pd(0)/SiO2-CoFe2O4) were in situ generated during the hydrolysis of ammonia borane, isolated from the reaction solution by using a permanent magnet and characterized by ICP-OES, XRD, TEM, TEM-EDX, XPS and the N-2 adsorption-desorption techniques. All the results reveal that well dispersed palladium(0) nanoparticles were successfully supported on silica coated cobalt ferrite and the resulting Pd(0)/SiO2-CoFe2O4 are highly active, magnetically isolable, and recyclable catalysts in hydrogen generation from the hydrolysis of ammonia borane with an unprecedented turnover frequency (TOF, calculated on the basis of the total amount of Pd) of 254 mol H-2 (mol Pd min)(-1) at 25 +/- 0.1 degrees C. The reusability tests reveal that Pd(0)/SiO2-CoFe2O4 are still active in the subsequent runs of hydrolysis of ammonia borane providing 100% conversion. Pd(0)/SiO2-CoFe2O4 provide the highest catalytic activity with a TOF value of 198 mol H-2 (mol Pd min)(-1) in the 10th use in hydrogen generation from the hydrolysis of ammonia borane as compared to the other palladium catalysts. The work reported here also includes the kinetic studies depending on the temperature to determine the activation energy of the reaction (E-a = 52 +/- 2 kJ/mol) and the effect of catalyst concentration on the rate of hydrolytic dehydrogenation of ammonia borane, respectively. (C) 2013 Elsevier B.V. All rights reserved.Article Citation - WoS: 5Citation - Scopus: 6Microporous vanadosilicate films with tailorable V4+/V5+ratio to achieve enhanced visible-light photocatalysis(Elsevier, 2021) Kuzyaka, Duygu; Uzun, Ceren; Yildiz, Ilker; Kaya, Murat; Akata, BurcuThis study investigates the changes induced into the photocatalytic activity under solar light irradiation upon changing the structural film properties and tailor the concentration of defects in microporous vanadosilicate AM6 films. For this purpose, the preparation of AM-6 films with different V4+/V5+ ratios and their utilization as photocatalysts for the decomposition of MB were carried out. Two approaches were used for obtaining AM-6 films with different V4+/V5+ ratios: altering the seed layer coating technique and altering the molar water content of the secondary growth gel. It was seen that dip coating method resulted in an increase in the thickness of the films and it was presumed that the adsorption of MB by AM-6 films was the predominant factor in photocatalytic activity. The second approach of increasing the molar water content of the secondary growth gel provided an increase in the defect concentration resulting in an enhanced photocatalytic activity under the solar light. In the current study, the defect concentration of the prepared films was determined by using XPS and Raman spectroscopy techniques. Accordingly, it was determined that the samples with lower amount V4+/V5+ ratio showed better photocatalytic activity under the solar light irradiation indicating that V5+ cations are responsible for the photocatalytic activity under visible light irradiation. This work provides methods of production of microporous films showing photocatalytic activity under visible light without the requirement of any post-synthesis treatments.Article Citation - WoS: 16Citation - Scopus: 17Synthesis, Characterization and Application of High Sulfur Content Polymeric Materials From Fatty Acids(Elsevier, 2023) Berk, Hasan; Kaya, Murat; Topcuoglu, Mert; Turkten, Nazli; Karatas, Yunus; Cihaner, AtillaA new series of high sulfur content polymers containing various amounts of fatty acids (oleic acid (OA), linoleic acid (LA) and linolenic acid (LnA)) was synthesized via inverse vulcanization method and characterized successfully. In particular, the effect of double bonds and free alkyl chains on polysulfur copolymers has been investigated systematically by using OA with one double bond, LA with two double bonds and LnA with three double bonds. The copolymers with functional carboxylic acid groups are soluble in common organic solvents, processable and electroactive. Also, the usage of the copolymers was tested in the removal of methylene blue and as a cathode material in Li-S battery. Results showed that the polymers can be a potential material for use in dye removal.Article Citation - WoS: 19Citation - Scopus: 20Synthesis, Characterization, and Enhanced Formic Acid Electrooxidation Activity of Carbon Supported Mnox Promoted Pd Nanoparticles(Elsevier, 2018) Bulut, Ahmet; Yurderi, Mehmet; Alal, Orhan; Kivrak, Hilal; Kaya, Murat; Zahmakiran, MehmetFormic acid (HCOOH) is one of the promising fuels for direct liquid fed fuel cells. However, CO poisoning is a major challenge for the development of effective catalytic system for formic acid electrooxidation (FAEO). Herein, a novel CO-resistive activated carbon supported Pd-MnOx bimetallic catalyst (Pd-MnOx/C) was presented for FAEO. Pd-MnOx/C catalyst was prepared via simple and reproducible surfactant-free deposition-reduction technique. The characterization of this novel Pd-MnOx/C catalyst was performed by inductively coupled plasma-optical emission spectroscopy (ICP-OES), powder X-ray diffraction (PXRD), X-ray photoelectron spectroscopy (XPS), bright field transmission electron microscopy (BFTEM), high resolution transmission electron microscopy (HRTEM), scanning transmission electron microscopy (STEM), and scanning transmission electron microscope-energy dispersive X-ray spectroscopy (STEM-EDX). The characterization results revealed that Pd and MnOx nanoparticles (NPs) were well dispersed and separately nucleated with a mean diameter of 2.9 nm on the surface of active carbon. FAEO studies were performed on both Pd-MnOx/C and Pd/C catalysts to comprehend the effect of separately formed MnOx on the electrocatalytic activity of Pd NPs. The electrochemical measurements were carried out by using Cyclic Voltammetry (CV) and Chronoamperometry (CA), CO-Strriping Voltammetry, Lineer Sweep Voltammetry (LSV), Electrochemical impedance spectroscopy (EIS) techniques. Electrochemical results revealed that FAEO was activated by the addition of MnOx. Pd-0.6-Mn-0.4 exhibited the optimum catalytic activity with 1.05 A/mg Pd current density. The sum of their results clearly points that the existence of MnOx NPs enhances the electrocatalytic activity of Pd NPs by increasing their CO-resistivity and durability throughout the FAEO. (C) 2018 The Society of Powder Technology Japan. Published by Elsevier B.V. and The Society of Powder Technology Japan. All rights reserved.
