Browsing by Author "Pepelnjak, T."

Now showing 1 - 2 of 2

Citation - WoS: 13
Citation - Scopus: 13
Analysis of Non-Isothermal Warm Deep Drawing of Dual-Phase Dp600 Steel
(Springer France, 2019) Pepelnjak, T.; Kayhan, E.; Kaftanoglu, B.
Improving the formability of the material is a key issue in the deep drawing process. Heating the material above its recrystallization temperature drastically increases formability, but in the case of dual phase (DP) steels, it results in a loss of their mechanical properties. To improve the drawing ratio, only the heating of the flange region in the warm temperature range up to 573K was studied on DP600 sheet steel by numerical simulation. A thermo-elastic-plastic finite element method (FEM) analysis of deep drawing at several drawing ratios was performed and compared with experimental results. During the experiments, the flange area of the blank was heated by induction heating, and the central part over the punch was cooled with spray water. Experimental results showed that limiting drawing ratio could be increased by 25.58%. The microstructure of the DP 600 steel was analyzed before and after the warm forming process. No significant changes were observed, and the high strength properties of the DP 600 steel remained intact. There was good agreement between numerical and experimental results.
Citation - WoS: 1
Citation - Scopus: 1
Finite Element Analysis of Non-Isothermal Warm Deep Drawing of Dual Phase Steel
(E D P Sciences, 2016) Pepelnjak, T.; Kaftanoglu, B.
Improving the formability of the material is an important issue in the deep drawing process. Heating the material above its recrystallization temperature drastically increases formability but in the case of dual phase (DP) steels it results in the loss of their mechanical properties. To improve the drawing ratio, only the heating of the flange region in the warm temperature range up to 300 degrees C was studied on DP600 sheet steel by numerical simulation. Thermo-elastic-plastic FEM analysis of deep drawing at several drawing ratios was performed and compared with experimental results.