Namlu, Ramazan HakkiLotfi, BahramKilic, S. EnginYilmaz, Okan DenizAkar, SametMechanical EngineeringDepartment of Mechanical EngineeringManufacturing Engineering2024-07-052024-07-05202311091-03441532-248310.1080/10910344.2023.22248602-s2.0-85163000847https://doi.org/10.1080/10910344.2023.2224860https://hdl.handle.net/20.500.14411/2172Sadigh, Bahram Lotfi/0000-0002-3027-3734; Namlu, Ramazan Hakkı/0000-0002-7375-8934; Yilmaz, Okan Deniz/0000-0002-5431-4334The drilling of shape-memory alloys based on nickel-titanium (Nitinol) is challenging due to their unique properties, such as high strength, high hardness and strong work hardening, which results in excessive tool wear and damage to the material. In this study, an attempt has been made to characterize the drillability of Nitinol by investigating the process/cooling interaction. Four different combinations of process/cooling have been studied as conventional drilling with flood cooling (CD-Wet) and with minimum quantity lubrication (CD-MQL), ultrasonic-assisted drilling with flood cooling (UAD-Wet) and with MQL (UAD-MQL). The drill bit wear, drilling forces, chip morphology and drilled hole quality are used as the performance measures. The results show that UAD conditions result in lower feed forces than CD conditions, with a 31.2% reduction in wet and a 15.3% reduction in MQL on average. The lowest feed forces are observed in UAD-Wet conditions due to better coolant penetration in the cutting zone. The UAD-Wet yielded the lowest tool wear, while CD-MQL exhibited the most severe. UAD demonstrated a & SIM;50% lower tool wear in the wet condition than CD and a 38.7% in the MQL condition. UAD is shown to outperform the CD process in terms of drilled-hole accuracy.eninfo:eu-repo/semantics/closedAccessMinimum quantity lubricationNiTishape memory alloyultrasonic-assisted drillingArticleQ2Q2274325349WOS:001012951600001