Guler, EnverSadeghi, SahlGursel, Selmiye AlkanChemical Engineering2024-07-052024-07-05201890360-31991879-348710.1016/j.ijhydene.2018.03.0872-s2.0-85044597529https://doi.org/10.1016/j.ijhydene.2018.03.087https://hdl.handle.net/20.500.14411/2684Gürsel, Selmiye Alkan/0000-0002-7966-6352; Güler, Enver/0000-0001-9175-0920The effect of divinylbenzene (DVB) as crosslinker on the graft polymerization of 4-vinylpyridine (4VP) from poly(ethylene-co-tetrafluoroethylene) (ETFE) films was studied. The resulted films were doped with phosphoric acid (PA) and characterized for mechanical, surface, thermal properties, and fuel cell performance. The crosslinked membrane obtained from grafting a mixture of 4VP with 1% DVB improved the polymerization kinetics and resulted in about 50% graft level depending on graft conditions. The crosslinked membranes were also found to have better mechanical properties compared to its non-crosslinked counterpart. The resulted membrane exhibited proton conductivity as high as 75 mS/cm under 50% relative humidity (RH) at 120 degrees C, besides almost doubling the power output of fuel cell compared to a non-crosslinked membrane. To the best of our knowledge, DVB crosslinked 4VP based ETFE membranes were, for the first time, tested in practical fuel cell test station correlating their performance to operating temperature. Furthermore, surface properties of produced membranes were additionally correlated to the degree of crosslinking. Humidity dependence is less pronounced in the produced membranes resulting in strong potential for testing at intermediate temperature (80-120 degrees C) polymer electrolyte membrane fuel cells. (C) 2018 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.eninfo:eu-repo/semantics/closedAccessRadiation-induced graftingDivinylbenzeneCrosslinkingProton conducting membraneIntermediate-temperature fuel cellArticleQ1431680888099WOS:000430897000032